Can anyone comment on RSP redundancy with SSO mode? Hw-module slot r0 reloaded

Hw Module Slot R0 Reload During Hw Module Slot R0 Reload free spins, you can also benefit from extra multipliers. In some titles, you can only land high-paying symbols during free spins, which is fantastic. All Hw Module Slot R0 Reload these perks make free spins a brilliant opportunity to make some amazing profits! Reload the Cisco WebEx Node SPA using the hw-module subslot reload command. Closest casino to boca raton fl beach. Prairie knights casino online application. Router# show platform software process slot r0 monitor cycles 4 interval 3 top - 18:26.

I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done Reload

Hw-module Slot R0 Reloadable

this:
service single-slot-reload-enable
redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :

Hw-module Slot R0 Reloader

------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa Hw-module slot r0 reloader

Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information : Hw-module slot r0 reloaded

-------------------------------

Hw-module Slot R0 Reloading

Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE

Hw-module Slot R0 Reloaded

(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
Hw-module

ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/